PrevPrev Go to previous topic
NextNext Go to next topic
Last Post 22 Apr 2015 07:46 PM by  Reanimotion
Firmware version [FrankenCIS 15.4.4]
 2 Replies
Sort:
You are not authorized to post a reply.
Author Messages
Reanimotion
System Designer
Basic Member
Basic Member
Posts:125


--
04 Apr 2015 08:39 AM
    updated firmware now available
    http://www.frankencis.com/Portals/2..._04_04.zip

    addresses a number of issues with DPR control and changes tuning methods slightly so a retune will be needed for any vehicles running on 2014 firmware

    Changes:
    CIS-E resolution and frequency changed to 200 steps and 1.85khz
    Split k-Jet duty gauge into eWUR and DPR specific items
    Implemented PWM idle on IGN2 for MicroSquirt v2.0 (useful on others but requires interface circuit to TTL output)
    Implemented Fuel Cut for CIS-E (overrun and redline)
    DPR tuning now roughly equates to mA
    Reanimotion
    System Designer
    Basic Member
    Basic Member
    Posts:125


    --
    12 Apr 2015 07:11 PM
    Source code released and available from the downloads page here
    http://www.frankencis.com/Portals/2...5.4.4k.zip
    Reanimotion
    System Designer
    Basic Member
    Basic Member
    Posts:125


    --
    22 Apr 2015 07:46 PM
    in the 5.4.4 release there is a bug in the tuner studio gauge calculation for Control Pressure meaning it will display a lower than actual value
    re-download 5.4.4 and update your ini file from the zip again - they are dated 22 April instead of the 4th
    From within Tuner Studio
    File menu
    Projects
    Project properties
    Then tick the browse box
    Find the file and load


    or go into your project folder and in the projectcfg edit maincontroller.ini

    at line 5400 or near the bottom you want to update the two lines to read
    kJetCP = { adc6 } ; Setup for converting 0-5.01V = 0 - 700kPa where cp0=-86.2, cpmax=775.7
    kJetSP = { adc7 } ; Setup for converting 0-5.01V = 0 - 700kPa where cp0=-86.2, cpmax=775.7

    You are not authorized to post a reply.